Epoxy Coated Bucket
White Epoxy Coated 2 1/4" gallon bucket. The "referee" bench mark for collecting and devaluating visual samples and sump draining for visual inspection for color, dirt and water.
5gal Sampling Can
Double coated epoxy lined fuel sample shipping containers. Specifically to transport samples of aviation fuel for laboratory testing to DOT standards. For more information see Bulletin No.99
1gal Sampling Can w/3/4" Bung
Double coated epoxy lined fuel sample shipping containers. Specifically to transport samples of aviation fuel for laboratory testing to DOT/IATA standards. To check aviation fuels see your shipping codes for restrictions at
Bulletin No. 99
⅓ U.S gallon- In-Tank Sampler
The unique model GTP-9021 was developed specifically to fit through the small gauging found on U.S. Air Force bases where level gauging electric cables are also present. It was important that there be no tangling of our sampler with those cables and that those cables not be damaged. Therefore, the outside diameter is only 3.1 in (79 mm).
For more information see
Bulletin No.115
1 U.S gallon In-Tank Sampler
With a one-gallon capacity, our model GTP-9090 is welcomed by technicians because they no longer must collect repeated samples to obtain enough liquid for the laboratory tests.
Sample Collection Pumps
The new version of this product has been
designed so that the cover will fit a Mason
jar as well as a bottle. The stopped will fit
any drink bottle or common gallon jug. For more information see
Bulletin No.85
Bacon Bomb (Bottom Sampler)
A plunger keeps the sampler closed until it strikes the bottom of the tank, then the sampler fills. When raised, the plunger automatically falls back into position, closes the sampler, and prevents any contamination by liquid taken at a higher level. This device picks up sediment or water directly off the bottom of the tank.
But a sample can be taken at any point above the bottom by attaching a cable to the top of the plunger, raising it at will to fill the sampler and lowering it to close the sampler. However, average sampling operations cannot be performed with the perfect control possible with the average model.
Sampling Probe
This probe is made to reach the center of a 4" pipe but can be used in any pipe sized 2" or larger. It is available in four preset lengths: 2 1/4", 4", 6".
NSN# 6695002364339 (for the standard 2 1/4" length probe)
For more information see
Bulletin No.3
Stainless Steel Tank Gauging Tapes
The stainless steel tape has a brushed surface,which aids in identifying the limit of the wetted surface on either dark or clear fuels.
Chrome Tank Gauging Tapes
The chromium plated steel tape is exceptionally
good for dark oils because the contrast between
the wetter and non-wetted surface is easily
recognized. For more information see Bulletin 129
Sampling Adapter
Thermal Controls type sampling adapter, used with the Multi MiniMonitor. Fits Cobham-UK (Flight Refueling Ltd.) Model #4127335 and #4127365 sampling adapters.
3/4 BSPP threads.
For more information see
Bulletin No. 8
Sampling Adapter
Shell Int'l type sampling adapter used with the Multi MiniMonitor. Fits Cobham-UK (Flight Refueling Ltd) Model #4127320, #4127345 and #4127350 sampling adapters.
13/16-16 UN threads.
NOTE: This fitment is the same as produced by A. Searle & CO., Stanhope Seta Ltd., and Holbek-Leba.
For more information see
Bulletin No. 8
Combination Double-Ended Adapter
Double-ended actuator used with the Multi Mini Monitor. The longer end fits the standard Jet Test QD. The shorter end fits the short or AH models of the Jet Test QD.
For more information see
Bulletin No. 8.
