Aljac Continuity Tester, 25 Ohms Setting

Home > Bonding & Grounding >

ADVANCED MICROPROCESSOR TECHNOLOGY.
GONO GO CONTINUITY CHECK.
DIGTAL RESISTANCE DISPLAY.
DYNAMIN CHECKING OF BONDING REELS.
SIMPLE T OPERATE, AUTO SWITCH ON/OFF
ROBUST AND IMPACT RESISTANT.

USD: (Registered Users Only)

Product Code: 0100400180

Qty:

Description

The Aljac Continuity Tester (ACT) is a foolproof Go/No Go device which can be used by non-skilled personnel, and it is controlled by a microprocessor which offers significant operational advantages. It self-checks calibration and available battery power and only then allows the test to proceed. The ACT uses a single dual color light emitting diode (LED) to indicate the condition of the bonding system under test, which makes the results very simple to interpret. The default set point is 25 Ohms which is in accordance with the JIG Guidelines for aviation fuel systems, but alternative set points can be specified at the time of order placement. In addition, throughout the test, a two-figure digital display tells the operator the actual system resistance (in Ohms).

Features

Self-Checking and self-calibrating before each operation. Dual color LED indicator to give a green signal for a resistance of 10 Ohms or less and a red signal for resistance more than 25 Ohms. Note that the indicator will be green at 25 ohms and turn red when the resistance goes over 25 Ohms. Fitted with (2) 2M long flying leads with test probes and sealed for battery life, automatic switch on and off after 15 seconds. The unit also has a two-figure digital display to show the system resistance (can be turned off if specified). ATEX approved for use in Zone 1 or Zone 2 hazardous areas.